Pesquisa Agropecuária Brasileira
URI permanente para esta coleçãohttps://thoth.dti.ufv.br/handle/123456789/9886
Navegar
9 resultados
Resultados da Pesquisa
Item Maturation and detachment force for mechanized harvesting of irrigated Conilon coffee in the Brazilian Cerrado(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-02-17) Santin, Mateus Rollemberg; Amabile, Renato Fernando; Malaquias, Juaci Vitória; Veiga, Adriano Delly; Brige, Felipe Augusto Alves; Sala, Pedro Ivo Aquino LeiteThe objective of this work was to determine the force required to detach fruits of Conilon coffee (Coffea canephora) genotypes in five maturation stages, to determinate the best stage for mechanized harvest, and to verify the possibility of future selections of genotypes adapted to mechanized harvesting. Harvests were carried out in the 2013/2014 crop season, and the detachment force was determined based for six fruits from each side of the crop row, collected randomly from the middle third of the plants. The detachment force curve was obtained for each cycle through logistic regression, using the R software. According to the duration of their cycle, the genotypes were divided into super early, early, medium, and semilate; the values of the coefficients of the detachment force curve equation were also obtained. There is genetic variability regarding fruit detachment force throughout the maturation cycle, which indicates the possibility of selecting genotypes adapted to mechanized harvesting. Fruit detachment force shows a considerable drop in the final stages of maturation. The raisin stage is the best for the mechanized harvest of irrigated Conilon coffee in the Cerrado.Item Chemical attributes of an Oxisol with the addition of conilon coffee straw biochar(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023) Alvarenga, Anarelly Costa; Passos, Renato Ribeiro; Andrade, Felipe Vaz; Mendonça, Eduardo de Sá; Rangel, Otacílio José Passos; Mosa, Lázaro LongueThe objective of this work was to evaluate the effects of increasing rates of biochar produced with coffee straw, at two pyrolysis temperatures, on the chemical attributes of an Oxisol cultivated with conilon coffee (Coffea canephora) and on the nutrient content of coffee tree leaves. Treatments consisted of pyrolysis at two temperatures (350 and 600 °C) and of five biochar rates (0, 5, 10, 15, and 20 Mg ha-1). The following soil chemical attributes were evaluated: pH in water; P, K, Ca, Mg, Al, H+Al, Zn, Cu, Fe, and Mn contents; effective and potential cation exchange capacity (CEC); sum of bases (SB); base (V) and aluminium (m) saturation; and N, P, K, Ca, Mg, Zn, Cu, Fe, and Mn contents in the leaves. The biochar produced at 600°C, at rates of 10 and 15 Mg ha-1, promoted a greater K release into the soil. Regardless of temperature, coffee straw biochar increased K and P availability, sum of bases, base saturation, and CEC in the soil, but did not influence macro- and micronutrient contents in the leaves. The addition of increasing rates of coffee straw biochar in the soil increases P, K, Mg, SB, CEC, and V, regardless of pyrolysis temperature.Item Morphophysiological responses of Conilon coffee matrix plants in a super-dense clonal garden(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-12-04) Silva, Josimar Aleixo da; Esposti, Marlon Dutra Degli; Senra, João Felipe de Brites; Comério, Marcone; Conceição, Amanda Oliveira da; Zacarias, Alex Justino; Milheiros, Idalina Sturião; Silva, Uliana Ribeiro; Silva, Fernanda Gomes da; Raimundo, Eduarda GonçalvesThe objective of this work was to evaluate the morphophysiological responses and cutting production of clones of Conilon coffee (Coffea canephora) cultivars in a super-dense clonal garden in the state of Espírito Santo, Brazil. The super-dense clonal garden was built in 2019 using 39 clones: 9, 9, 9, and 12 of cultivars Centenária ES8132, Diamante ES8112, ES8122 (Jequitibá), and Marilândia ES8143, respectively. The experiment was carried out in a randomized complete block design, with three replicates. Cutting production and the following morphophysiological traits were evaluated at 9 and 18 months after planting: chlorophyll index, normalized difference vegetation index, plant height, canopy height, canopy diameter, number of shoots, number of viable cuttings, number of leaves, fresh leaf mass, and plant fresh and dry matter mass. The super-dense clonal garden caused different morphophysiological responses among the studied clones. In general, clones C2, C5, C6, C8, D1, D8, D9, J8, M2, M9, M10, and M12 showed a higher mean cutting production, whereas C4, J1, J4, M4, and M5 were the most sensitive to the super-dense regime. Under these conditions, it is recommended to increase the proportion of matrix plants of the latter clones.Item Chemical attributes of an Oxisol with the addition of conilon coffee straw biochar(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-05-19) Alvarenga, Anarelly Costa; Passos, Renato Ribeiro; Andrade, Felipe Vaz; Mendonça, Eduardo de Sá; Rangel, Otacílio José Passos; Mosa, Lázaro LongueThe objective of this work was to evaluate the effects of increasing rates of biochar produced with coffee straw, at two pyrolysis temperatures, on the chemical attributes of an Oxisol cultivated with conilon coffee (Coffea canephora) and on the nutrient content of coffee tree leaves. Treatments consisted of pyrolysis at two temperatures (350 and 600°C) and of five biochar rates (0, 5, 10, 15, and 20 Mg ha-1). The following soil chemical attributes were evaluated: pH in water; P, K, Ca, Mg, Al, H+Al, Zn, Cu, Fe, and Mn contents; effective and potential cation exchange capacity (CEC); sum of bases (SB); base (V) and aluminium (m) saturation; and N, P, K, Ca, Mg, Zn, Cu, Fe, and Mn contents in the leaves. The biochar produced at 600°C, at rates of 10 and 15 Mg ha-1, promoted a greater K release into the soil. Regardless of temperature, coffee straw biochar increased K and P availability, sum of bases, base saturation, and CEC in the soil, but did not influence macro- and micronutrient contents in the leaves. The addition of increasing rates of coffee straw biochar in the soil increases P, K, Mg, SB, CEC, and V, regardless of pyrolysis temperature.Item Morphophysiological responses of Conilon coffee matrix plants in a super-dense clonal garden(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2023-12-04) Silva, Josimar Aleixo da; Esposti, Marlon Dutra Degli; Senra, João Felipe de Brites; Comério, Marcone; Conceição, Amanda Oliveira da; Zacarias, Alex Justino; Milheiros, Idalina Sturião; Silva, Uliana Ribeiro; Silva, Fernanda Gomes da; Raimundo, Eduarda GonçalvesThe objective of this work was to evaluate the morphophysiological responses and cutting production of clones of Conilon coffee (Coffea canephora) cultivars in a super-dense clonal garden in the state of Espírito Santo, Brazil. The super-dense clonal garden was built in 2019 using 39 clones: 9, 9, 9, and 12 of cultivars Centenária ES8132, Diamante ES8112, ES8122 (Jequitibá), and Marilândia ES8143, respectively. The experiment was carried out in a randomized complete block design, with three replicates. Cutting production and the following morphophysiological traits were evaluated at 9 and 18 months after planting: chlorophyll index, normalized difference vegetation index, plant height, canopy height, canopy diameter, number of shoots, number of viable cuttings, number of leaves, fresh leaf mass, and plant fresh and dry matter mass. The super-dense clonal garden caused different morphophysiological responses among the studied clones. In general, clones C2, C5, C6, C8, D1, D8, D9, J8, M2, M9, M10, and M12 showed a higher mean cutting production, whereas C4, J1, J4, M4, and M5 were the most sensitive to the super-dense regime. Under these conditions, it is recommended to increase the proportion of matrix plants of the latter clones.Item New model of clonal garden for the production of robusta coffee plantlets(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2022-09-12) Espindula, Marcelo Curitiba; Araújo, Larissa Fatarelli Bento de; Diocleciano, João Maria; Rocha, Rodrigo Barros; Dias, Jairo Rafael Machado; Verdin Filho, Abraão CarlosThe objective of this work was to evaluate the production of cuttings of Coffea canephora genotypes, in a new system for training mother plants called “vertical clonal garden”. The proposed new system consists of training coffee plants with only one shoot and without bending the main shoot, so that the secondary orthotropic shoots, from which the clonal cuttings will be taken, are formed across the length of the stem in the vertical direction. The capacity for the production of cuttings of ten hybrid genotypes of coffee plants was evaluated over ten production cycles. The 'BRS 2314', 'BRS 3213', and 'BRS 3210' genotypes showed cutting production per cut of 425,000 cuttings per hectare, considered above the obtained average. The 'BRS 3193', 'BRS 2336', 'BRS 3220', and 'BRS 3137' genotypes were the least productive. Coffee plants trained in the “vertical clonal garden” system can produce about 425,000 cuttings per hectare per harvest period or about 1.275 million cuttings per hectare per year, over three harvest periods, with a greater ease in crop management and treatments.Item Yield of robusta coffee in different spatial arrangements(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2021-12-10) Espindula, Marcelo Curitiba; Tavella, Leonardo Barreto; Schmidt, Raquel; Rocha, Rodrigo Barros; Dias, Jairo Rafael Machado; Bravin, Maísa Pinto; Partelli, Fábio LuizThe objective of this work was to determine the contribution of the number of stems to the composition of individual plant yield, and to individual and overall robusta coffee (Coffea canephora) yield at different planting densities, using a fixed number of stems per plant. The experiment was carried out in two phases. The first phase was performed from 2011 to 2015, in the municipality of Ouro Preto do Oeste, in the state of Rondônia (RO), Brazil, to evaluate different numbers of stems per plant (1, 2, 3, 4, 5, and 6). The second phase was conducted from 2013 to 2018, in the municipality of Alta Floresta D’Oeste, RO, to evaluate plant densities (at 1,666, 1,904, 2,222, 2,666, and 3,333 plants ha-1), with an initial density of four stems per plant in all treatments. The increase of number of stems per plant promotes a quadratic response to the average and cumulated yield of coffee plants, and the maximum yield is attained with four stems per plant. The number of stems should not exceed four, to avoid their tipping during years of high production. Plant density of 3,333 plants per hectare, with 4 stems per plant and 1 m spacing, promotes the reduction of individual plant yield; however, it results in higher overall crop yield.Item Spatial distribution of the root system of Conilon and Arabica coffee plants(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2020) Partelli, Fabio Luiz; Cavalcanti, André Cayô; Menegardo, Camilo; Covre, André Monzoli; Gontijo, Ivoney; Braun, HederThe objective of this work was to evaluate the root system of Conilon coffee (Coffea canephora) and Arabica coffee (Coffea arabica) plants in the soil profile, using semivariograms. The evaluations were carried out in an area located in the municipality of Jaguaré, in the state of Espírito Santo, Brazil. The Verdebrás G30/G35 Conilon coffee and the Catuaí Vermelho IAC 44 Arabica coffee cultivars were assessed. Soil monoliths with coffee plant roots were collected at three distances from the trunk in the planting row and at six distances from the trunk between rows, at six depths. The roots were collected and washed and then digitized and processed in the Safira software. The spatial variability of the evaluated attributes was characterized by the geostatistical technique, through semivariograms, using the GS+ 7.0 software. Root surface area, length, and volume were quantified for the two coffee species. Conilon coffee plants have a tendency of showing a root system with a smaller surface area, shorter length, and lower volume by volume of soil, as well as a less discrepant distribution on soil surface and in deeper layers, compared with Arabica coffee.Item Mechanized harvesting of 'Conilon' coffee clones(Empresa Brasileira de Pesquisa Agropecuária - Embrapa, 2020) Souza, Gustavo Soares de; Lani, José Antônio; Infantini, Maurício Blanco; Krohling, César Abel; Senra, João Felipe de BritesThe objective of this work was to evaluate the speed effect of a coffee harvester and its interaction with 'Conilon' coffee (Coffea canephora) clones on the mechanical harvesting efficiency. The experiment was installed in São Mateus, in the state of Espírito Santo, Brazil, in 2012, with 27 clones of early, intermediate, and late fruit ripening. The first harvest was performed after the plant cuttings at 0.5 m above the ground, in 2016, and the canopy renovation. The plants and the harvester were evaluated in 2018. The coffee harvester was tested at 0.6 and 0.8 km h-1. Measurements were performed for stripping and harvesting efficiencies, fruit loss on the ground, unstripped fruit, defoliation with manual and mechanized harvesting, fruit removal force, and fruit ripening degree. The tests with the coffee harvester indicated a technical feasibility of 88% average harvesting efficiency, and a 15% lower defoliation than the manual harvesting. The harvesting speed of 0.8 km h-1 results in higher stripping and harvesting efficiencies, in a lower percentagem of loss on the ground, and in less unstripped fruit, regardless of the evaluated clones. Fruit removal force and ripening degree influence the stripping and harvesting efficiencies and the percentage of unstripped fruit of 'Conilon' coffee.