Periódicos
URI permanente desta comunidadehttps://thoth.dti.ufv.br/handle/123456789/3352
Navegar
2 resultados
Resultados da Pesquisa
Item Compaction caused by mechanized operations in a red-yellow latosol cultivated with coffee over time(Editora UFLA, 2012-07) Martins, Paula Cristina Caruana; Junior, Moacir de Souza Dias; Andrade, Maria Luiza de Carvalho; Guimarães, Paulo Tácito GontijoThe main source of soil structure degradation in coffee plantation is the machinery traffic because these operations may cause soil compaction affecting the crop development. This study aimed to generate the load-bearing capacity models for a Red-Yellow Latosol and to determine through the use of these models the soil susceptibility to compaction of the coffee plantation due to the implantation time and the compaction caused by the machinery traffic on the traffic lines located at the top and bottom of the ground. This study was carried out in the EPAMIG Experimental Farm, located at Três Pontas, MG, in coffee plantations (Coffee arabica L.) with 2, 7, 18 and 33 years of establishment. To obtain the load-bearing capacity models, 12 undisturbed soil samples were randomly collected in the 0-3 cm and 15-18 cm layers in the position between the rows for each establishment time of the coffee plantation. It was also randomly collected 10 undisturbed soil samples for each establishment time of the coffee plantations along the tractor traffic lines located at the top and bottom of the ground. These undisturbed soil samples were used in the uniaxial compression tests. The use of the load-bearing capacity models allow to identify the soil susceptibility to compaction due to the implementation time of the coffee plantation and the compaction caused by the machinery traffic on the traffic lines located at the top and bottom of the ground. The percentage of compacted soil samples increases with the establishment time in the layer of 15-18 cm.Item Comparison of field and laboratory models of the load bearing capacity in coffee plantations(Editora UFLA, 2013-03) Iori, Piero; Dias Junior, Moacir de Souza; Ajayi, Ayodele Ebenezer; Guimarães, Paulo Tácito Gontijo; Pais, Paula Sant'Anna Moreira; Andrade, Maria Luiza de CarvalhoPrecompression stress is an important property for assessment of tropical soil structure sustainability and is often determined in laboratory tests. The objective of this study was to compare the load bearing capacity models obtained with controlled moisture in laboratory and those obtained with natural field moistures determined a long one year. The evaluation of soil structural sustainability follows four distinct steps: soil sampling in the field, uniaxial compression test of the samples in the laboratory, determination of precompression stress and estimation of the load bearing capacity models. Laboratory estimates of precompression stress were obtained from moisture controlled in laboratory and from natural moisture determined in a field a long one year. In this process, the soil samples were saturated by capillarity with distilled water in laboratory, and after 48 hours, the samples were air dried to obtain the different moisture contents. Then, the precompression stress was determined for this both conditions. To verify if the load bearing capacity models obtained with controlled moisture in laboratory may represent the load bearing models obtained with natural field moisture, these models were compared using the homogeneity test procedure. It was observed that 75% of field models analyzed were similar to the laboratory models. Thus, due to the similarity on the load-bearing capacity models obtained using natural (field) or controlled (laboratory) moisture contents, the assessment of the soil structure sustainability can be done using both methods.